Husqvarna TC 112 Operator's Manual page 14

2. Put the steering wheel (A) on the steering column.
The pins on the steering column must go into the
slots in the steering wheel.
3. Install the washer (B) and the bolt (C). Tighten the
bolt to 24 Nm.
4. Install the center cover (D) on the steering wheel.
The center cover is attached with snap locks.
To install the knob on the throttle
control
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
1. Put the knob (A) onto the throttle control lever.
A
C
2. Install the nut (B) and the screw (C).
To install the seat
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
14
1. Hold the seat in position and install the 2 screws (A)
and the 2 nuts (B).
D
C
B
A
A
2. Do a check of the operator presence control. Refer
Operation conditions on page 10 .
to
To adjust the seat
1. Fold the seat forward.
2. Loosen the 2 quick knobs.
3. Move the seat until it is in a position where you can
push the pedals down fully.
4. Tighten the 2 quick knobs fully.
To install the tow bar
B
Refer to
fasteners for this task.
B
WARNING:
product if the operator presence control
is defective.
Assembly overview on page 13 for the correct
A
Do no operate the
1903 - 004 - 18.12.2023