Husqvarna TC 112 Operator's Manual page 32

1. Remove the cutting deck. Refer to
install the cutting deck on page 29 .
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
To replace the blades
1. Lock the blades with a wooden block.
A
B
C
2. Remove the bolt (A), the washer (B), and the blade
(C).
3. Install a new left blade on the left side and a
new right blade on the right side. The left blade is
identified with "Left" and the right blade is identified
with "Right".
CAUTION:
different direction of rotation. The right
blade must be installed on the right side
and the left blade must be installed on
the left side.
32
To remove and
R
L
The blades have
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
and install the cutting deck on page 29 .
4. Make sure that the bent ends on the blades point in
the direction of the cutting deck.
5. Torque the bolts to 80 Nm.
To replace the cutting deck belt
1. Remove the cutting deck. Refer to
install the cutting deck on page 29 .
2. Remove the dirt and grass around the bearing
housings, blade pulleys and from the top surface of
the cutting deck.
3. Remove the bolt (A), the washer (B) and the idler
pulley (C).
A
B
C
4. Remove the cutting deck belt (D) from the blade
pulleys on the cutting deck.
5. Install a new cutting deck belt in the opposite
sequence.
a) Make sure that the cutting deck belt is in the
correct position in all belt pulleys.
CAUTION:
cutting deck belt is not twisted. Refer
to the belt routing decal on the cutting
deck.
To adjust the anti-scalp wheels
The anti-scalp wheels keep the cutting deck in the
correct position on the ground and prevent lawn scalping
in most terrain conditions. The anti-scalp wheels are
Incorrect blade type
To remove
To remove and
D
Make sure that the
1903 - 004 - 18.12.2023