Advertisement
VI
8a.
8b.
10.
Compressor Replacement
COMPRESSOR KIT INSTRUCTIONS
Make sure unit is turned off and unplugged.
Use a Phillips screwdriver to remove the bolt for the filter access door.
Use a Phillips screwdriver to remove the bolt for the compressor cover.
Pull compressor cover off.
Use a 9/32" socket to loosen the hose clamp. for the compressor discharge line.
Slide hose off barbed elbow.
Use a 1/8" hex (Allen) wrench to remove front compressor mounting shoulder
bolts.
Slide compressor assembly out of unit, by pulling in a horizontal direction.
Disconnect compressor harness by depressing the side of the plug and then.
gently pull out.
Disconnect spaded terminal connections (4) on older style Breeze units, which
do not have Molex quick disconnect harness.
Reverse steps #8 thru #1 to install new compressor
assembly.
Note, make sure
compressor assembly is positioned on springs, such that the rubber grommets
are inserted into the spring ends and the mounting bolts are centered.
_
Plug-in unit and run to verify performance.
If unit is excessively noisy, the
compressor assembly is not mounted in an optimum manner.
Page 12
Advertisement
