Advertisement
4
Entering lnitialization Data (continued)
Did the format on Figure 2-1 appear on your display terminal?
YES
NO
1
ls this the first time you have reached this step?
YES
NO
1
0
Have you just completed Chapter 1 setup instructions7
YES
NO
1
0
Go to Chapter 4, Part 2, and perform the External Port Test
and return to this point.
Were the tests successful?
YES
NO
1
0
Replace the 7426 by following your local
procedures.
O
The problem is external to the 7426. Notify your
supervisor.
0
The problem is external to the 7426. Notify your supervisor.
O
Be sure that a communication cable is attached to the display.
0
Be sure that the display power cable is attached to a proper outlet.
D
Restart with Procedure 1 of this chapter.
0
Use either the Tab key or the Backspace key to move the cursor
(position marker). Enter the data shown on the lnitialization
Worksheet.
O
When all positions are completed, hold the Alt key down and press the
D key on the 3101. lf you are using a 7485, press the Accept key.
2-4
Advertisement
