Siemens SICHARGE UC Panto Kit Repair Instructions page 39

Power box repair cases
7.6 PCB - Output
Electrical schematic
Figure 7-8 Electrical schematic - PCB - Output
Instructions
1. Label the cables with the connected terminals or take a photo if sufficient.
2. Disconnect all the cables from the PCB.
3. Unscrew the four semi-transparent nuts.
4. Remove the old PCB.
5. Replace it with a new PCB.
6. Reconnect the cables to the same terminals as before, according to the picture or label.
7. To configure the PCB follow the instructions described in SIpdater
(https://siemens.sharepoint.com/:b:/r/teams/eMobilityServiceCollaboration/SiteAssets/SitePa
ges/SICHARGE_UC_PDF_Article_Manual/UC%20HowTo_SIpdater.pdf?csf=1&web=1&e=oZAw
0V).
8. Restart the system and test the exchanged device.
38
SICHARGE UC Panto Kit Repair Instructions
Service Manual, 04/2024, A5E53652973-AA