Siemens SICHARGE UC Panto Kit Repair Instructions page 20

6. Disconnect the flat yellow wires or remove the small PCB by unscrewing the two semi-
transparent nuts.
7. Exchange the old PCB - Linux Board.
8. Reconnect the flat yellow wires or screw again the small PCB to the back of the PCB - Linux
Board.
9. Connect the white flat cable to the HMI display.
10. Screw again the new PCB - Linux Board (2 screws on the left side, 2 screws on the right
side).
11. Reconnect and screw all the connection terminals as before, according to the picture or
labels.
12. Install the required software on the new PCB - Linux Board.
13. Restart the system and test the exchanged device.
SICHARGE UC Panto Kit Repair Instructions
Service Manual, 04/2024, A5E53652973-AA
Control box repair cases
6.3 PCB - Linux Board (-KE02)
19