Matrox Morphis Evo Installation And Hardware Reference page 25

Caution
Cable used
With a 3.3 V wire (A)
Missing a 3.3 V wire (B)
3. Attach the SATA cable to the board's SATA power connector.
When attaching the SATA power supply cable to the board's SATA power
connector, do so carefully and slowly to avoid lifting the SATA connector and
loosening its attachment to the board.
After attaching the SATA cable, the power LED will turn on (turn green) if the
jumper on the power selector connector has been set appropriately for your SATA
cable. For more information about the power LED, see the LEDs subsection of
the Matrox Morphis Evo board connectors and LEDs section in Appendix B Technical
information.
Supplying power to your board
Pins selection
2-3
❖
This is the default jumper
position when the board is
shipped.
1-2
Jumper image
Jumper
1 2 3
pin pin pin
Toward bracket
Jumper
1 2 3
pin pin pin
Toward bracket
25