Advertisement
Available languages
Available languages
10. High speed
11. Light button
12. On off
Control Panel. Model UBCA2011-23: (See
image 9 on page 6)
13. Light
14.
Maximum speed
15. Average speed
16. Low speed
17. On/off button.
Use (both models)
• Press the on/off button to turn the
extractor hood on or off.
• Press the desired speed button to use
speed from 1 to 3, with 1 being the lowest
speed and 3 being the highest speed.
• Press the light button to turn the light
on and off, one touch being on and 2
touches being off.
For model UBCA2012-23
• When the hood is operating at the
required speed, press the speed symbol
that is operating for 2 seconds to activate
the timer. The hood will automatically
shut down after 15 minutes.
• To stop the timer, press again the speed
symbol that is operating for 2 seconds,
the hood will work normally.
CLEANING AND MAINTENANCE
Follow these cleaning and maintenance
indications to prevent any deterioration of
your hood due to time and use:
• Wait until the appliance is switched off
and not hot to carry out the cleaning
and/or maintenance.
• Use a cloth, soap and lukewarm water
to clean the surfaces and then dry them
with a soft, clean cloth.
• Do not use any scrubber, nor any
abrasive cleaning product, or any
product that may contain caustic soda,
acids, chlorides or solvents. Do not use
high pressure or steam jet cleaners
either.
• Be careful when cleaning the surface
of the control panel, if water gets inside
there may be electric shock risk.
• Do not use any cleaning products
with high levels of caustic alkaline
or acids. More specifically do not use
any commercial or industrial cleaning
products to clean any aluminium part,
such as the anti-grease filters of the
extraction hood.
• Clean very carefully the inside of the
appliance.
Note: Consider the warnings indicated in
the cleaning products.
Cleaning the appliance
• Proceed to clean as indicated below,
according the surface type:
• Clean the stainless-steel surfaces
with a cloth and hot water with some
soap and rub in the direction of the
grain.
• Clean the lacquered surfaces with a
cloth and hot water with some soap
• Clean the aluminium surfaces with a
soft cloth and some window cleaner.
• Clean the plastic parts with a soft
cloth and some window cleaner.
• Clean the glass parts with a soft cloth
and some window cleaner.
• Dry with a soft cloth.
Cleaning the control panel
• Be especially careful with this area to
prevent any water from getting inside.
Cleaning the anti-grease aluminium filter
•
It is recommended to clean it every 2
months, depending on the use and the
grease build-up.
•
Remove the filter by pressing the fixing
tab (help yourself with the other hand
so that the filter does not tilt, and the
grease accumulated does not spill)
•
If your filters are dishwasher safe, you
can put them in the dishwasher to
clean them (Check this information
related to your model in table x on page
x). Otherwise never clean them using
this method.
•
If you are going to clean them in the
EN
25
Advertisement
