Advertisement
Available languages
Available languages
Follow these indications to save
energy when using the appliance:
Adjust the extraction power to
•
the current needs, the lower the
extraction power, the lower the
energy consumption will be (do
not use the appliance improperly
just to save energy, it is more
important to use it responsibly)
Turn the light of the appliance
•
off if you do not need to use it.
Use the cooking pots with their
•
lids.
Steam and water condensation
•
are reduced (using the hood
might not be necessary)
Do not use the additional functions
if they are not necessary.
PRODUCT FEATURES
To see the parts of the product see picture 1
and 2 on page 4.
Note: The picture is for reference only. The
content may vary depending on the model.
1. Hood
2. Chimney
You can check the product features in
table 01 and 02 on page 7.
ASSEMBLY AND INSTALLATION
Before using this appliance, remove the
packaging and inspect the product. If the
device could be damaged, please contact
the store where you purchased it.
• The manufacturer will not be held
responsible for damages caused to the
product due to incorrect installation.
• Installation may only be carried out by
qualified personnel.
• Two or more people are required to
install or move this appliance. Failure
to do so may result in bodily injury.
• The minimum distance between the
hood and the burners should not be less
than 650mm and a maximum distance
of 750mm, to obtain the best results.
(See image 4 on page 4).
• Distances greater than 750 mm are at
the discretion of the installer and the
user, provided that the height of the
ceiling and the length of the flue allow
it..
Installation (see image 5 on page 5)
When installing the range hood, please
read the following installation instructions
carefully:
Note: Remove protective plastic from all
parts of the hood and chimney before final
installation.
• Fix the hood mounting bracket to the
wall using M5*45mm screws and
M10*45mm wall anchors.
• Align the hood body with the installed
mounting bracket and gently lower
the hood until it hangs securely on the
bracket.
• With M3*6 screws fix the air outlet
adapter. Attach a length of 150mm to
the air outlet adapter.
• Then fit the flexible tube.
• Carefully place the chimney body on
the top of the hood and use M2.9*14
screws to fix it.
• Carefully insert the second section of
the chimney and slide it into position.
Use M4*6 screws to fix it.
• To prevent the hood body from moving,
use M4.2*30 screws to fix the hood
inside.
Install the duct for hoods with air outlets
to the outside. (See image 3 on page 4)
• Decide where you want to install the
duct. Consider that a short, straight
duct run will allow the hood to operate
more efficiently.
• Long ducts with bends or transitions
will reduce the performance of the
EN
23
Advertisement
