Table of Contents
Advertisement
C300 User Guide
Using
T
urning on
Press
for 2 to 5 seconds to turn the device on. The C300 plays a power up melody.
T
urning off
Press
for more than 5 seconds to turn the device off. The C300 plays a power down melody.
C
onnecting to a Windows PC via USB
Plug the USB cable into the USB-C port on the C300. Plug the other end of the cable into the USB-A
port on the PC.
When the C300 is recognized by the PC, the circle LEDs turn green for two seconds. The
speakerphone becomes the external audio device of the PC.
C
onnecting to Snom deskphone, Windows PC, or mobile device via
Bluetooth pairing
Two sets of Bluetooth paired devices can be connected to the C300, but only one device can be
activated at a time.
1. When the C300 is idle, press
2. Open the Bluetooth menu on your Snom deskphone with Bluetooth capability, PC, or mobile device
and, if necessary, start Bluetooth or WLAN scanning/detection.
3. Select Snom C300 from the list of available devices.
4. If you are asked for a PIN code, enter 0000.
If pairing was successful, the C300 plays three ascending tones. The circle LEDs turn blue for two
seconds.
If pairing failed, the C300 plays three rapid tones. The circle LEDs briefly blink blue every three
seconds. Try again or try pairing with a different Bluetooth device.
NOTE: The C300 keeps a record of the last four paired Bluetooth devices. To clear the
record, press
tones to indicate success.
P
airing a mobile device using NFC
1. On your mobile device, turn NFC on.
2. Place the NFC zone of your mobile device against the NFC zone of the C300 (indicated by
When NFC is detected, the speakerphone plays a tone. The circle LEDs turn white for one second.
for two to five seconds. The circle LEDs flash blue.
for more than five seconds. The speakerphone plays three ascending
13
Using the C300
).
Advertisement
Table of Contents
