Lfo1 (Low Frequency Oscillator 1) - Yamaha FS1R Owner's Manual

LFO1 (Low Frequency Oscillator 1)

• 01: Waveform
Waveform
Settings: tri, s-dn, s-up, squ, sine, s/h
Determines the waveform of the LFO.
tri (Triangle)
squ (Square)
• 02: Speed
Speed
Settings: 0 ... 99
Sets the speed of the LFO. "0" is the slowest Speed setting, A setting of "99" produces the fastest LFO variation.
• 03: Delay
Delay
Settings: 0 ... 99
Sets the delay time between the beginning of a note and the beginning of LFO operation. The minimum setting "0"
results in no delay, while a setting of "99" produces the longest delay before the LFO begins operation.
• 04: Key Sync
Key Synchronization
Settings: off, on
Determined whether the LFO runs continuously (off), or is triggered by notes played (on) so that modulation always
begins from the same point in the LFO waveform when a note is played.
• 05: PitchMod Dpt
Pitch Modulation Depth
Settings: 0 ... 99
Sets the maximum amount of pitch modulation that can be applied to the current voice. A "0" setting produces no
modulation while a setting of "99" produces maximum modulation. Pitch modulation produces a periodic pitch
variation, thereby creating a vibrato effect.
No effect will be produced if EDIT [VOICE] mode OPERATOR/Sns/Pitch Mod parameter (page 69) is set to "0".
s-dwn (Downward sawtooth) s-up (Upward sawtooth)
sine (Sine) s/h (Sample and hold)
51