Others - Yamaha FS1R Owner's Manual

• 13: Loop End
Loop End (Only available when 03: Mode = fseq)
Settings: 0 ... 511*
Specifies the loop end point for Fseq playback. The highest available value corresponds to the end of the formant
sequence. Higher values shift the loop end point toward the end of the sequence.
If the loop end point is set at a lower value than the loop start point (above), the formant sequence will play
backwards.
* 511 is the maximum setting. The actual range will depend on the selected Fseq data.

Others

• 01: IndOut
Individual Output
Settings: off, pre ins, post ins
This parameter, in conjunction with the insEfSw parameters for each part (page 26), determines how the individual
parts are assigned to the FS1R's INDIVIDUAL OUTPUT jacks. When "off" no signal is delivered via the individual
outputs. When set to "pre ins" only parts for which the InsEfSw parameter is turned "on" will appear at the individual
outputs, and the sound will be "dry" (without effects). When set to "post ins" the sound of all parts will appear "post
insertion effect" at the individual outputs.
Loop Start < Loop End
Frame0 Keyon LoopStart
Offset
Loop Start > Loop End
Frame0 LoopEnd LoopStart
KeyOff
LoopEnd FrameEnd(max511)
KeyOff
Keyon FrameEnd(max511)
Offset
35