SendIns Rev
Insertion-to-Reverb Send Level
Settings: 0 ... 127
Sets the amount of signal sent from the output of the insertion effect stage back to the input of the reverb effect
stage (see diagram on page 13). The higher the value, the more insertion signal is sent to the reverb stage.
SendIns Var
Insertion-to-Variation Send Level
Settings: 0 ... 127
Sets the amount of signal sent from the output of the insertion effect stage back to the input of the variation effect
stage (see diagram on page 13). The higher the value, the more insertion signal is sent to the variation stage.
InsDryLevel
Insertion Dry Level
Settings: 0 ... 127
Sets the level of the "dry" (direct) sound in relation to the insertion effect sound. Higher values produce a "drier"
signal.
EQ
This is a versatile 3-band equalizer with variable frequency and Q (bandwidth) for all bands. The low and high
bands can be switched for peaking or shelving operation.
Low Freq
Low-band Frequency
Settings: 32 ... 2.0k
Sets the rolloff or center frequency of the low EQ band.
Low Gain
Low-band Gain
Settings: -12 ... 0 ... +12
Sets the amount of boost ("+" settings) or cut ("-" settings) applied to the low EQ band.
Low Q
Low-band Q
Settings: 0.1 ... 12.0
Sets the Q or bandwidth of the low EQ band when the "peak" mode is selected via the "Low Shape" parameter,
below. Higher values produce a narrower bandwidth. The Q parameter cannot be adjusted when the "shelv" mode
is selected.
Low Shape
Low-band Shape
Settings: peak, shelv
Determines whether the low EQ band has a peaking or shelving response. The "Low Q" parameter, above, only
becomes available when the "peak" mode is selected.
48