Others - Yamaha FS1R Owner's Manual

• 03: PB Range
Pitch Bend Range
Settings: -48 ... +24
This parameter sets the maximum amount of pitch bend which will occur when the pitch controller is set to its
maximum position (e.g. when the pitch bend wheel on a keyboard is rolled all the way up). Minus setting produce a
downward pitch bend. Each increment corresponds to a semitone. A setting of "+12", for example, results in
maximum upward pitch bend of one octave.
• 04: PB Range Lo
Pitch Bend Low Range
Settings: -48 ... +24
"PB RangeLo" sets the maximum amount of pitch bend which will occur when the pitch controller is set to its lowest
position (e.g. when the pitch bend wheel on a keyboard is rolled all the way down). Plus settings produce an
upward pitch bend. Each increment corresponds to a semitone. A setting of "-12", for example, results in maximum
downward pitch bend of one octave.
• 05: Porta Sw
Portamento Switch
Settings: off, on
Turns portamento "on" or "off". When "on" the portamento effect will be produced as determined by the "Porta
Mode" and "Porta Time" parameters, below.
• 06: Porta Mode
Portamento Mode (Only available when 05: Porta Sw = on)
Settings: Ful, Fng
Portamento produces a "slide" effect between subsequently played notes. The "Porta Mode" parameter determines
how the portamento slide is produced. When "Ful" is selected the portamento slide will occur between any two
subsequent notes when the "Porta Sw" parameter, above, is "on" even if the first note is released before the second
is played. When "Fng" (Fingered) is selected the portamento slide will only occur if the first note is still held when the
second note is played.
• 07: Porta Time
Portamento Time (Only available when 05: Porta Sw = on)
Settings: 0 ... 127
The "Porta Time" parameter sets the portamento time (i.e. the length of the slide between notes). A setting of "0"
produces the fastest portamento time; "127" produces the longest portamento slide effect.

Others

• 01: Mono/Poly
Monophonic/Polyphonic Mode
Settings: mono, poly
Selects the FS1R monophonic or polyphonic note mode. When "mono" is selected the note priority is determined by
the setting of the Priority parameter, below.
41