Videx 6200 Series Manual

6200 Series
Art. 6296
3.5" touchscreen videophone for IPure system
27 mm
A
B
C
Fig. 1 Front
DESCRIPTION
3.5" TFT high-resolution LCD monitor, OSD, capacitive touch
screen, 4 buttons configurable for functions: door open, inter-
com call, auto start, camera switching, timed privacy service.
12Vdc or PoE power supply.
2 inputs / 2 outputs.
Wall mounted, white or black finish.
VIDEOPHONE INITIALISATION
If powering on the videophone (through a PoE switch/router or
an external power supply unit) the display shows the message
"DEVICE NOT INITIALISED", use the configuration software IPure
Wizard to setup the device and the system.
LEDS
Privacy on LED
It illuminates when the privacy service is enabled.
Service LED
It flashes slowly if the gateway is not found.
If turned on, the device has failed to register with the
configured SIP server.
Missed call LED C
It flashes slowly if there is a missed call.
Art. 6296 - Installation instructions
144 mm
F
D E
G
H
Fig. 2 Inside
LEGEND
A Touchscreen display
B Tactile programmable
buttons and LED's
C Missed call LED
D Call tone volume control
E Brightness control
F Handset
G Induction coil for hearing
aid users
To download the programming software
IPure Wizard and obtain the latest firmware
and manuals please visit the following web-
site and register
https://service.videx.it/
The informations contained in this manual are valid
for devices with software version 2.5.0 and later.
CONTROLS
Call tone volume control
3 level switch (it controls also the local bell volume).
Display brightness control
Sliding wheel.
Microphone volume trimmer
It increases the volume from the handset to the door
panel loudspeaker.
- 1 -
I
L
E
D
H Connection terminals
I Ethernet connector
L Microphone volume trimmer
L
66251115 - V5.5 - 31/03/24
Rev.0.1