Parameters of PTZ
Configure and Invoke Preset Positions
You can configure preset positions and quickly rotate the camera to a preset position by invoking the
preset position.
The procedure is as follows:
Step 1 Configure a preset position.
1. Choose the preset ID.
2. Adjust the direction of PTZ to finish the preset position setting.
3. Click
Step 2 Invoke a preset position.
Select a preset position from the Preset list to invoke the preset position. Click
The special presets: Set No.64 preset, the PTZ functions restore to factory settings .
----End
Configure and Invoke Tracks
You can record a track to allow the camera to repeatedly rotate based on the preset track.
Step 1 Configure a track.
1. Set the track ID and name.
2. Click
3. Use arrow keys in the PTZ Control area to set a required a track.
4. Click
14
to save, click to rename.
Invoke No.92 preset, set the start point of scan.
Invoke No.93 preset, set the end point of scan.
Invoke No.97 preset, it will invoke the SCAN 1.
Set No.97 preset, view the version of MCU and chip.
Invoke No.99 preset, scan by rotating 360° .
Invoke No.250 preset, enable the MCU temperature.
Invoke No.251 preset, disenable the MCU temperature.
Set No.252 preset, the PTZ parameters will be restore to factory settings.
Invoke 103 preset, the brush works once, this function is only for PTZ cameras with brush.
to set the starting position of the track.
to finish the track setting.
Camera User Manual
icon to invoke.
Issue V 1.1(2021-08-12)