LawnMaster GV1212B Operator's Manual page 5

IMPORTANT SAFETY INSTRUCTIONS
fit fully into the wall outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician
to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or
extension cord plug in any way.
■ Make sure your extension cord set is in good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product will draw. For lengths less than 50 feet, a
No. 14 AWG extension cord should be used. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating.
■ Store idle scarifier/dethatcher indoors. When not in use, the tool should be stored in an indoor dry
and locked-up place-out of reach of children.
■ Maintain the tool with care. Keep cutting edges sharp and clean for best and safest performance.
OPERATION
■ Only operate the equipment in daylight or good artificial light.
■ Do not put hands or feet near under rotating parts or the scarifier/dethatcher. Keep clear of the
discharge opening at all times.
■ Avoid holes, ruts, bumps, rocks, or other hidden hazards. Uneven terrain could overturn the tool, or
cause operator to lose their balance or footing.
■ Do not direct discharge material toward anyone. Avoid discharging material against a wall or
obstruction. Material may ricochet back toward the operator.
■ Always wear safety glasses with side shields. Everyday glasses have only impact resistant lenses.
They are NOT safety glasses. Following this rule will reduce the risk of eye injury. Use a face mask
if operation is dusty.
■ Wear safety glasses or goggles that are marked to comply with ANSI Z87.1 standard when
operating this tool.
■ Always be sure of your footing. A slip and fall can cause serious personal injury.
■ Do not operate the tool in reverse unless absolutely necessary. Always look down and behind
before and while backing.
■ Always be sure the cylinder has stopped after releasing switch lever and unplugging before removing
and replacing collection bag, cleaning, servicing, transporting or lifting the scarifier/dethatcher.
■ Stay behind the handle when the motor is running.
■ Do not force the tool. It will do the job better and safer at the rate for which it was designed.
■ Stop the motor and disconnect the plug from power source whenever leaving the equipment, before
cleaning the scarifier/dethatcher housing, and before making any repairs or inspections.
■ Do not operate the tool on excessively steep slopes.
■ Avoid starting and stopping on slopes. Avoid making sudden changes in speed or direction. Make
turns slowly and gradually.
■ Stay alert. Watch what you are doing. Use common sense. Do not operate the scarifier/dethatcher when
you are tired.
■ Do not overreach. Keep proper footing and balance at all times.
■ Do not abuse the cord. Never use the cord to pull the tool or to disconnect the plug from an outlet.
Keep cord away from heat, oil, sharp edges, or moving parts. Replace damaged cords immediately.
Damaged cords increase the risk of electric shock.
■ Do not make the equipment overload, such as scarify too deep or operate at a very high speed.
■ Only use parts and accessories made for this tool by the manufacturer. Failure to do so can result in
personal injury.
■ Thoroughly inspect the area where the equipment is to be used and remove all stones, sticks, wires,
bones, and other foreign objects.
5