Table of Contents
Advertisement
Introduction
This document provides hardware and software installation procedures for the Xilinx
U55C data center accelerator card and applies to XRT 2021.1 and later.
If you encounter any issues during installation, see
Different system configurations are available for running, developing, and debugging applications
on your Alveo accelerator cards:
• Running Applications: To run accelerated applications, install an Alveo card into a system as
described in
Chapter 3: Card Installation Procedures
software to support running applications as described in
Software.
• Developing Applications: To develop FPGA accelerated applications, it is necessary to install
both the deployment software and the development software. Development software
installation, described in
and the Vitis environment. This configuration does not have an Alveo card installed and is
used for development along with debugging in emulation modes.
• Running, Developing, and Debugging Applications: By installing the Alveo card along with
both the deployment and development software on a single machine, you can configure a
system for developing and running accelerated applications. With the card installed,
developers can debug applications in both emulation modes and on the hardware.
UG1468 (v1.0) November 23, 2021
Alveo U55C Data Center Accelerator Card Installation Guide
Chapter 7:
Chapter 6: Next
Steps, installs both a development target platform
Chapter 1: Introduction
Troubleshooting.
along with the required deployment
Chapter 4: Installing the Deployment
Send Feedback
Chapter 1
®
Alveo™
www.xilinx.com
5
Advertisement
Table of Contents
