Etwork Onnection - ICP DAS USA LinPAC-2841 Series User Manual

3.3.2 Network Connection
1. After user follow step 5 "Console Connection" to connect to the device bash terminal, user can
change the default network setting:
Interface
IP
User ID
Password
2. If user want to use DHCP to set the network configuration, user can use the command
modify the configuration file "/etc/network/interfaces".
3. Using the '#' to mark the eth0/eth1's default configuration and saving the file. Please refer to
below Fig 3-2:
4. After saving the new network setting, user can use the command "/etc/init.d/networking" to
enable the setting.
5. User can use the new network setting to connect to the device.
LinPAC-2841 Series User Manual
LAN1 (eth0)
DHCP
root
icpdas
Fig. 3-2 DCHP/Static IP Setting
Version 1.0
LAN2 (eth1)
DHCP
"vi" to
page: 16