Advertisement
ii) Custom location
The location of a detector can be customized or completely modified. The U•H1 unit enters
Location Edit Mode when the Custom Location function has been selected.
The cursor flashes on the character being edited.
The Up and Down arrow keys allow the selected character to be edited.
The user confirms their choice of location by pressing ENTER.
The user can interrupt and cancel the editing of the location by pressing ESC.
b) Setting a detector to "Out of order"
Navigation:
Service menu
It may be useful to set a detector offline while waiting for an authorized person to conduct a
maintenance operation. When the Out of order function has been selected, the U•H1 unit
shows the status of the selected detector.
The user can set the detector to "Out of order" by pressing ENTER. Confirmation is then
requested.
The user confirms that the detector should be set offline by pressing ENTER. The technical-
fault relay then switches on if it has not already switched.
The user may interrupt and cancel the procedure for setting the detector to offline at any
time by pressing ESC. The configuration menu for the selected detector is then enabled
once more.
The user can set a detector to online again in the same way.
A detector being "out of order" is a technical fault. This means that the fault relay switches
on!
DALEMANS sa/nv
Rue Jules Mélotte 27A
B-4350 Remicourt
+32 19 33 99 43
Location channel 1
Channel 1
Configuration
→
Out of order setting
Enabled
Out of order setting
Put out of order?
Out of order setting
Out of order
U•H1 Instruction Manual
Channels setting
→
31
|
50
Out of order
→
setting
Certified
ISO9001 • VCA
www.dalemans.com
Advertisement
