Advertisement
3 CONFIGURATION
3.1 Configuration mode
The configuration mode for the U•H1 unit comprises a set of menus that allows the system
settings to be configured. The user can access these menus, regardless of the status of the
U•H1 unit, by pressing ENTER on the keyboard (if the display is in standby, the user should
first exit standby mode by pressing any key). Once in this mode, the display backlighting
turns blue.
The U•H1 unit automatically exits configuration mode after an idle period of 60 seconds (a
period in which no action is performed using the keyboard) and returns to the appropriate
mode: normal mode, if no faults or alarms have been signaled; fault mode, if a fault, but no
alarms, have been signaled; or alarm mode if an alarm has been signaled.
3.2 Configuration principle
The factory settings for the U•H1 unit are intended for heater rooms and may be changed
depending on the intended use.
The measuring channel is deactivated in the factory. A detector-detection script must be run
(see § 5.3.1 Initializing the detector).
A gas-detection system controlled by the U•H1 unit must be configured as follows:
1.
Detect the detector and activate the input channels.
2.
Select the appropriate "standard config."
3.
[Optional] Adjust the settings specific to the installation.
These operations require the intervention of qualified technicians. Contact DALEMANS
sa/nv for more information.
DALEMANS sa/nv
Rue Jules Mélotte 27A
B-4350 Remicourt
+32 19 33 99 43
U•H1 Instruction Manual
16
|
50
Certified
ISO9001 • VCA
www.dalemans.com
Advertisement
