Advertisement
Level 1 alarm mode
Level 1 siren mode
Channels info
External alarm info
Error reset mode
4.3.1 Base standard configuration
Navigation:
Info menu
This is the base standard configuration, based on which the device was configured. The
U•H1 is a device that allows a wide range of configurations.
Modifications to the configuration can be made following this selection.
Please contact a DALEMANS sa/nv representative for more details about custom
configurations.
4.3.2 Alarm thresholds
This item from the Con figuration info menu allows to view the configured alarm thresholds,
for each alarm level, beyond which the control unit goes into alarm mode.
4.3.3 Relays failsafe modes
The safety mode of a relay defines its status when it is at rest:
▪
Not in failsafe mode: the relay is not powered at rest.
▪
Failsafe mode: the relay is powered at rest.
The failsafe mode of an alarm relay is unset by default. The failsafe mode of each alarm
relay is independently configurable.
By default, all relays are 'Not failsafe,' except for the fault relay which is always 'Failsafe.'
DALEMANS sa/nv
Rue Jules Mélotte 27A
B-4350 Remicourt
+32 19 33 99 43
Alarm level 1 behavior: latching or non-latching
Alarm level 1 siren mode active/inactive
View the Channel Settings for the Unit
View the external alarm input parameters
Reset acknowledgment mode for error messages
Configuration info
→
U•H1 Instruction Manual
20
|
50
Base standard config.
→
Certified
ISO9001 • VCA
www.dalemans.com
Advertisement
