Table of Contents
Advertisement
Quick Links
LPG / ULPG MOBILE INDUSTRIAL DIRECT
FIRED AIR HEATER
BY BROMIC
INSTALLATION, INSTRUCTION AND
SERVICE MANUAL
MODELS:
HF70
WARNING: THIS HEATER IS APPROVED FOR
INDUSTRIAL USE ONLY
IMPORTANT: This heater should be installed and
operated in accordance to the manufacturers
instructions outlined within this manual. The user
shall ensure that local gas fitting regulations,
municipal building codes, AS/NZS 1596
other relevant statutory regulations are adhered
to. Use appliance only in a well-ventilated
space. Read and understand this manual before
attempting to assemble, operate and service the
appliance. Keep this manual for future reference.
and
Advertisement
Table of Contents
Related Manuals for Bromic Heating HF70
Summary of Contents for Bromic Heating HF70
- Page 1 FIRED AIR HEATER BY BROMIC INSTALLATION, INSTRUCTION AND SERVICE MANUAL MODELS: HF70 WARNING: THIS HEATER IS APPROVED FOR INDUSTRIAL USE ONLY IMPORTANT: This heater should be installed and operated in accordance to the manufacturers instructions outlined within this manual. The user...
- Page 2 IMPORTANT This manual contains important information about the assembly, operation, and maintenance of Blow Heaters. Please pay close attention to the important safety information shown throughout this instruction manual. Any safety information will be accompanied by the following safety alert symbols: DANGER, WARNING, IMPORTANT...
-
Page 3: Important Safety Instructions
WHEELS ASSEMBLY (FOR HF70) ・ Remove the heater from the carton box and remove ・ Place a washer on the exposed threaded portion of any Styrofoam transit protection and plastic packaging. -
Page 4: Guidelines Of Fuel Gases
Do not operate this heater in basement areas and below ground. OPERATING INSTRUCTIONS: Operator controls - Automatic model (HF70) PRE-START CHECKS AND WARNINGS: ・ The hose assembly shall be visually inspected prior to each use of the heater. If it is evident there is... -
Page 5: Switching Off The Heater
SWITCHING OFF THE HEATER and the cylinders removed from the heater. (NORMAL SHUT-DOWN) AUTOMATIC MODELS (HF70) ・ ・ Check the heater thoroughly for damage. Never valve first. operate a damaged heater. This includes damaged ・... -
Page 6: Specifications
SPECIFICATIONS blow heater. HF 70 Model Maximum Heat Output 234.7 MJ/h Gas Consumption 4.7 KG/H Burner type Single gas burner PCB controlled Ignition Type Automatic ignition Air Flow 1400 Propane (LPG) and Gas Type Universal (ULPG) gas only ” G – Left hand Gas Inlet Connection thread Injector Size... -
Page 7: Troubleshooting
TROUBLESHOOTING ・ The appliance is equipped with a self-fault diagnostic device. Any repair of the heater should only be carried out by a qualified technician. ・ Be sure the heater is disconnected from the gas cylinder before any repair work is undertaken. ・... -
Page 8: Maintenance And Storage
MAINTENANCE AND STORAGE ・ Keep the heater clean, especially the motor grid and fan blades. This should be done seasonally or sooner if used in dirty operating conditions. ・ Store the heater in dry, clean and safe place, away from the reach of children. ・... - Page 9 ILLUSTRATED PARTS BREAKDOWN AND PARTS LIST...Cont... HF 70 - AUTOMATIC MODEL Cover REF30/50 AUTO MODEL SPARE PARTS SCHEDULE Controller Box ITEM DESCRIPTION QUANTITY Cord Grommet Motor assembly Plug & Cord Solenoid valve Handle Indicating Lamp Wheel Flame Detection Needle Terminal block Burner Assembly Rubber bush Igniting Electrode...
- Page 10 ELECTRICAL SCHEMATIC - AUTOMATIC MODEL...