Table of Contents
Advertisement
Festa Smart Switch
LED Mode Switch Button
Press this button to switch the LED status indication between Speed and PoE.
Reset
With the switch powered on, press Reset button for 5 seconds to reset the switch to its factory default
settings.
10/100/1000 Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10 Mbps, 100 Mbps or 1000 Mbps.
SFP Slot
Designed to install the SFP module.
Port Feature
100M/1000 M/10Gbps
Model
Festa FS318GP
Festa FS328GP
Festa FS352GP
Rear Panel
■
The rear panel is shown as the following figure. The actual product may differ from the figure.
Figure 1-4
Rear Panel
Kensington Security slot
Kensington Security Slot
Secure the lock (not provided) into the security slot to prevent the device from being stolen.
Grounding Terminal
The switch already comes with lightning protection mechanism. You can also ground the switch through
the PE (Protecting Earth) cable of AC cord or with Ground Cable. For detailed lightning protection
measures, go to https://www.tp-link.com/support/?type=smb, search the model number of your switch
and go to the product Support web page, refer to the Lightning Protection Guide from the Related
Documents: https://www.tp-link.com/us/configuration-guides/lightning_protection_guide/.
Power Socket
Connect the female connector of the power cord here, and the male connector to the AC power outlet.
Make sure that the voltage of the power supply meets the requirement of the input voltage (100–240 V~
50/60 Hz).
Caution:
You should use the provided power cord.
03
Introduction
10/100/1000 Mbps
RJ45 Port
RJ45 Port
/
/
/
10/100 Mbps RJ45
Port
16
/
24
/
48
/
Grounding Terminal
SFP Slot
SFP+ Slot
2
4
4
Power Socket
/
/
/
Advertisement
Table of Contents
