Page 2
For Class A switch with power adapter: FCC Compliance Information Statement Product Name: Switch Model Number: Festa FS308G/ Festa FS308GP/ Festa FS310GP Component Name Model T120100-2B1 (For Festa FS308G) Power Adapter T535131-2-DT (For Festa FS308GP/ Festa FS310GP) Responsible party: TP-Link USA Corporation.
Page 3
Responsible party: TP-Link USA Corporation. Address: 10 Mauchly, Irvine, CA 92618 Website: https://www.tp-link.com/us/ Tel: +1 626 333 0234 Fax: +1 909 527 6804 E-mail: sales.usa@tp-link.com This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2011/65/EU and (EU)2015/863.
Page 5
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) L’appareil ne doit pas produire de brouillage; 2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що передбачені чинними законодавчими актами України. Safety Information ■ Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us. ■...
Page 7
Class II equipment with functional earthing Alternating current Direct current Polarity of d.c. power connector For indoor use only Dangerous voltage Caution, risk of electric shock Energy efficiency Marking Protective earth Earth Frame or chassis Functional earthing Caution, hot surface Caution Operator's manual Stand-by...
5–90% RH non-condensing Wall Mounting Requirements Festa FS308G/ Festa FS308GP/ Festa FS310GP To mount the device on a wall, use 2 screws which complies with ANSI B1.1 4#, (5#), 6#, 8# standard and are more than 8.5 mm in length. When the screws are fixed on the wall, the...
Page 9
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2011/65/EU and (EU)2015/863.
Page 12
Safety Information ■ Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us. ■ Place the device with its bottom surface downward. ■ Keep the device away from water, fire, humidity or hot environments. ■...
Page 13
For indoor use only Dangerous voltage Caution, risk of electric shock Energy efficiency Marking Protective earth Earth Frame or chassis Functional earthing Caution, hot surface Caution Operator's manual Stand-by "ON"/"OFF" (push-push) Fuse Fuse is used in neutral N...
Page 14
RECYCLING This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment.
Need help?
Do you have a question about the Festa FS308G and is the answer not in the manual?
Questions and answers