BARRON Exitronix LEMD Series Installation Instructions Manual

LEMD Series
Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• CAUTION: Do not join converter connector until installation is complete and AC Power is supplied to
the emergency driver,
• This product is for use with an emergency LED lighting load and supplies a maximum of 7W, 10W or 21W of
power and a maximum voltage of 48VDC in emergency mode for a minimum of 90 minutes.
• To reduce the risk of electric shock, disconnect both normal and emergency power supplies and converter
connector of the emergency driver before servicing.
• This emergency driver is suitable for both factory and field installation.
• This product is suitable for use in dry and damp locations.
• The ambient temperature for use is 0°C to 50°C (32°F to 122°F).
• Do not install outdoors.
• An unswitched AC power source of 120/277VAC, 60Hz is required.
• Do not install near gas or electric heaters.
• Do not attempt to service the battery. A sealed, no maintenance battery is used that is not field replaceable.
Contact the manufacturer for information on service.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Install in accordance with the National Electrical Code or Canadian Electrical Code and any local regulations.
• Do not use this product for other than intended use.
• Servicing should be performed by qualified service personnel.
• Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
• For use with a metal grounded enclosed wiring system or equivalent.
10070337 P1 - 11/23
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
Technical Support ■ (623) 580-8943 ■ technicalsupport@barronltg.com
1
800-533-3948 www.barronltg.com