Summary of Contents for BARRON Exitronix 900E Series
Page 1
900E Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
900E Series Installation Instructions Surface Ceiling, Surface Wall, or Flag Mount Fig. 1 J-box 1. Remove the end cap with the test button and LED indicator holes by loosening the (2) flat head screws Mounting Grommet and set aside (Fig. 1). Plate Homeplate 2.
900E Series Installation Instructions Pendant Mount 1. Secure the mounting bracket to the mounting surface using (2) screws (not provided). Mounting Bracket 2. Thread a lock nut on one end of the extension rod. Tighten the lock nut so it is not able to spin freely.
Page 4
900E Series Installation Instructions Fig. 1 Recessed Ceiling or Recessed Wall Mount J-box Grommet Recessed Note: If the “Rough-in Kit” for the 900E Series has been Housing preinstalled, proceed to step 6 below. 1. Cut a 3" x 15" opening in the ceiling or wall. Ensure that Hanger Bars the opening is less than the trimplate dimensions of...
900E Series Installation Instructions Fig. 4 8. Install the test button and LED indicator in the trimplate (Fig. 4). 9. Slide the panel assembly through the trimplate. 10. Secure the trimplate/panel assembly to recessed housing Test Button with (2) 6-32 X 3/4” screws. Indicator Trimplate Test Button and...
900E Series Installation Instructions Self-Test/Self-Diagnostics (G2) Operation The purpose of this option is to provide Self-testing and Self-diagnostic capabilities to the EXIT sign. At predetermined intervals, the EXIT sign will automatically switch into battery mode. Refer to the Self-Test Features section of this page for timing details.