Yale Living YRL216 Installation And Programming Instructions page 26

Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it
restricts all user (except Master) PIN code access. When attempting to enter a code while the
unit is in Lockout, the RED locked padlock will appear on the screen.
Audio Mode: The audio setting for PIN code verification is set to Enable (1) by default;
otherwise it can be set to Disable (3) for quiet areas.
Automatic Re-lock Time: After a successful code entry and the unit unlocks, it will
automatically re-lock after thirty (30) seconds.
Inside Indicator Light: Located on the interior escutcheon. Shows active status (Locked) of
lock and can be enabled or disabled in the Advanced Lock Settings (Main Menu selection #3).
Low Battery: When battery power is low, the Low Battery Warning indicator flashes RED.
If battery power is completely lost, use the cylinder key override.
Master PIN Code: The Master PIN code is used for programming and for feature settings.
It must be created prior to programming the lock. The Master code will also operate
(unlock/lock) the lock.
Network Module Setting: With the optional Network Module installed, this setting becomes
available thru the Main Menu (7) and allows the lock to connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch
(during Automatic Re-lock duration or when Automatic Re-lock is disabled). When One-Touch
Re-lock is not in use (disabled), any valid PIN code will re-lock the lock.
Shutdown Time: The unit will shutdown (flashing RED) for sixty (60) seconds and not allow
operation after the wrong code entry limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User PIN Code: The User code operates the lock. Maximum number of user codes is 250 with
Network Module; without Network Module, maximum is 25 user codes. Note: When deleting
User PIN code(s), screen will display User Number (not PIN code) being deleted.
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid PIN code,
the unit will shut down and not allow operation for sixty (60) seconds.