Removing And Installing Drives - LaCie 2big User Manual

LaCie 2big
User Manual

4. Removing and Installing Drives

In the event that an individual hard disk fails in
the LaCie 2big, please contact your LaCie reseller or
LaCie Customer Support. Please replace a defec-
tive hard drive only with a new drive provided by
LaCie. For drive removal and replacement process,
please follow the steps below.
CAUTION:
2big, drives may be hot. Use caution when remov-
ing.
To Remove a Drive:
1. Turn off and unplug the LaCie 2big.
2. The drive tray may be locked. To unlock it, insert a
coin into the slot on the drive lock and turn the lock
until the slot is vertical (Fig. 4-A).
3. Draw out the drive tray by inserting your finger into
the space behind the drive tray handle and pulling to
disengage the drive (Fig. 3.1-B).
4. Grasp the drive tray handle and carefully extract the
drive (Fig. 4-C).
To Install a Drive:
1. Turn off and unplug the LaCie 2big.
2. Carefully insert the drive tray into an empty drive
bay. When the drive tray is most of the way in and
you feel resistance, press the drive tray handle firmly
until you feel the drive snap into place and the drive
tray handle is flush with the back of the 2big.
3. Use a coin to lock the drive lock.
After continuous use of the LaCie
Removing/Replacing Drives
Drive warranty will be
ImpOrTANT INfO:
void if you replace the defective drive with a drive
not provided by LaCie.
Fig. 4-A
Fig. 4-B
Fig. 4-C
page