atd models ATD023 Instruction Manual page 7

4. Locate the Glazing Sheet and cut out the windows
along the thin outer lines. Then, glue each one
into position.
Ensure that the side wall glazing is glued to
i
Component B (the window openings on
Component A are slightly bigger).
5. Glue the side walls of Component B to the inside
of Component A's side walls.
The window openings on the inner layer are
i
slightly smaller than the outer openings to give
the model depth. Try to ensure that these are
centrally aligned.
6. Detach the Roof, fold it
along the crease line and
glue together.
9. Apply glue around the edge of the roof and
glue it into position, ensuring it's flush with the top
of the wall.
This can be a little fiddly if it's your first time doing
this so try to take your time.
Applying even pressure where the floor
meets the wall until it's semi-cured will ensure
a firm hold.
7. Detach the Roof Kerb, fold
it along the crease line and
glue together.
8. Glue the Roof Kerb to
the Roof.