atd models ATD023 Instruction Manual page 3

6. Form the Roof Kerbs.
Kerb A (x2) - Glue 3 x Packer A together. Repeat.
Kerb B (x2) - Glue 3 x Packer B together. Repeat.
Kerb C (x1) - Glue 3 x Packer C together.
Try to ensure the components are as flat/level as
i
possible. This will help to ensure roof is level on
the completed model.
7. Glue each Roof Kerb into postion.
Glue Kerb C to the back wall. Glue Kerb B(1) and B(2) to
the front wall (there will be a gap in the middle). Finally,
glue Kerb A(1) and A(2) to the side walls (we've designed
these to be snug!)
The top of each kerb should be flush with the
i
top of the wall.
8. Detach the Roof, fold it along the crease line and glue
together.
The sky light openings on one side of the roof are bigger
i
to avoid misalignment.
9. Locate the glazing sheet and cut out the Sky Lights
along the thin outer lines. Then, glue each one
into position.
Ensure you glue the sky lights to the printed side of
i
the roof.