Displays And Operation - ACP STYLE 1 Owner's Manual

Displays and Operation

STYLES 2 & 3
Cooking Displays
STYLE 2 STYLE 3
READY READY
00:00 00:00
% MW POWER COOK LEVEL
COOKING POWER
Programming Displays
STYLE 2 STYLE 3
PROGRAM PROGRAM
P0- P:0
P-- P:
OPTIONS OP:--
cf:0- CF:
stage- P:--
Interrupting Operation
While the oven is operating, press STOP/RESET keypad to
interrupt operation. Display shows remaining cooking time.
Close door and press START key to resume oven operation.
Canceling Mistakes
If oven is not cooking, press STOP/RESET keypad to clear
display. If oven is cooking, press STOP/RESET keypad once
to stop oven, then again to clear display. If oven door is open
and time shows in display, close oven door and press STOP/
RESET keypad to clear display.
Factory Preset Programs
All preprogrammed keypads arrive set at full power (100%).
KEYPAD TIME
1 10 sec.
2 20 sec.
3 30 sec.
4 45 sec.
5 1:00 min.
Note: Factory setting may vary by model
©2020 ACP, Inc.
Cedar Rapids, IA 52404
DESCRIPTION
Displays when oven control will accept entries
Displays cooking time. If stage cooking is programmed, total cooking time is displayed
Displays while oven is operating to show the percent microwave power level.
• Style 2: The % MW Power is displayed about as a number 10-90 in intervals of 10. If no
number is displayed, the oven is cooking at full power.
• Style 3: The cooking level is displayed above as a number 1 through 9. (1=10%, 2=20%,
3=30%, etc.) If no number is displayed, the oven is cooking at full power.
Displays while the oven is generating microwave energy during a cooking cycle.
DESCRIPTION
Displays when entering programming mode.
Displays when oven enters programming mode for single digit keypad memory only.
Displays when oven enters programming mode for double digit keypad memory. 2 keypads
must be pressed to enter a program.
Displays when oven is in user option mode. User options can then be set or specified.
Displays with a numerical cooking factor when the X2 keypad is pressed. Cooking Factor
is the percentage by which cooking time increases when using X2 keypad to cook multiple
portions. (1=10%, 2=20%, 3=30%, etc.)
Number (1 through 4) indicates the stage that is being programmed.
1
• Style 2: The stage # is displayed above cooking time.
• Style 3: The stage # displays briefly when programming a specific cooking stage.
KEYPAD TIME
6 1:30 min.
7 2:00 min.
8 3:00 min.
9 4:00 min.
0 5:00 min.
Operating Preset Program Keypads
From the factory, this oven comes preprogrammed with
several cooking sequences in memory.
Note: To change single or double keypad entry option see
"User Options" section in this manual.
1. Open oven door and place food in oven. Close door.
• Display shows "READY"
2. Select the keypad(s) for the desired preprogrammed
cooking sequence.
• Single Digit Keypad Cooking: press a keypad (0-9)
• Double Digit Keypad Cooking: press the two keypads,
in order, of the double digit number for the desired
cooking sequence.(00-99)
3. Oven begins cooking and displays remaining cooking
time.
4. If additional cooking time is required, press preset
program keypad(s) before or after cooking cycle ends.
5. At the end of the cooking cycle, the oven beeps. Carefully
remove food from oven.
Page 16 of 24
Part No. 20267401
Revised 9/2020