Page 1
Rodovia Ivo Silveira 9525 Volta Grande 88355-202 Brusque/SC/Brasil CNPJ: 82.983.032/0001-19 www.skymsen.com – Fone: +55 47 3211 6000 - Due to the constant improvements introduced to our equipments, the information contained in the present Instruction Manual may be modified without previous notice.
Page 2
SUMARY 1.1.6 When the equipment may have fall, have been damaged any way or simply does not work, take it to 1. INTRODUCTION ......2 Technical Assistance to check. 1.1 Safety ......... 2 1.1.7 The use of accessories not recommended by the 2.
All components of this equipment were designed and manufactured using carefully selected materials to their proper functions, according to test standards and The equipment must be placed on to a levelled stable experience of Skymsen. surface approximately 850 mm high. PICTURE 01 Recommended area for equipment installation...
Always use the Combs (Picture 05) to process any PICTURE 04 product. PICTURE 05 4. OPERATION 4.1 Starting PICTURE 05 To start the equipment: - Plug the equipment on the power point. - Press the ON/OFF Switch #.05(Pic.01) to position “I”. 4.2 Operation Procedures Under no circumstances use any instrument to feed the meat inside the Protection Lid # 01 (Pic.01).
Page 5
PICTURE 08 PICTURE 06 -Posicione The protective cover No. 02 (Pic. 07) with the rollers on a table. - Lift the front Rollers of Support No. 01 (Pic. 07) until the rolls of support lock disengage the existing plug-in protection cover No. 02 (Pic. 07), and pull it forward until it PICTURE 09 is totally out of the protective cap No.
Page 6
PICTURE 10 PICTURE 13 FLANGE 4.4 Safety System - Mount the second roll in its housing in the combs holder This equipment has a safety system that prevents drive as shown in Pic. 11. the machine automatically when power is restored after a PICTURE 11 temporary disconnection.
Never spray water directly to the equipment. 7. PROBLEM SOLVING The equipment has been designed to operate with the Use Your QR Code Reader to access more need of minimum maintenance but the natural wearing information regarding the cares needed caused by longer use of the equipment may occasionally when handling stainless Steel.
Page 8
TABLE 02 PROBLEMS CAUSES SOLUTIONS - Check if plug is connected to - Lack of electric power. its socket, or if there is electric - The machine does not switch on. shortage. - Problems with electrical circuit. -Call Technical assistance. - Problems with the electrical - Smoke or burnt smell.
Need help?
Do you have a question about the ABS and is the answer not in the manual?
Questions and answers