Installation - HAMPTON BAY DSHD5979E Use And Care Manual

Installation

1
Preparing the fixture body
□
Unscrew the two mounting screws (3) from the fixture body (B).
□
Remove the cage (2) and the EPE (1) from the fixture body (B) and
keep the cage (2) and the two mounting screws (3) for later use.
□
Thread the fixture loop (A) to the fixture body (B). Hand-tighten
until snug.
3
Testing ceiling canopy fit to the crossbar assembly
□
Remove the pre-assembled canopy lock ring from the crossbar assembly (AA).
□
Temporarily attach the ceiling canopy (EE) to the pre-assembled nipple on the crossbar assembly (AA).
□
Secure with the canopy lock ring.
NOTE: If the ceiling canopy is not snug against the ceiling, remove it from the crossbar assembly and adjust the length of the
pre-assembled threaded tube by unscrewing the pre-assembled hex nut.
Screw the threaded tube in or out of the crossbar until the correct length is achieved. Then, re-attach the ceiling canopy.
A
B
1
3
2
2
Installing the crossbar assembly
□
Secure the crossbar assembly (AA) to the outlet box (not
included) with the outlet box screws (BB). Tighten until
snug.
NOTE: The preassembled mounting threaded tube on
the crossbar should protrude outward.
Outlet box
AA
EE
Canopy lock ring
5
Please contact 1-855-HD-HAMPTON for further assistance.
AA
BB
HAMPTONBAY.COM