Wall-mounted condensing boilers with storage tank (104 pages)
Summary of Contents for Sime EDEA HM 40
Page 1
Cod. Condensing combi wall mounted boiler EDEA HM 40 USER MANUAL TO BE LEFT WITH THE OCCUPANT Gas Safety Certificate AS/NZS 5263.1.2: SAI-400433 Watermark Certificate AS/NZS 3498 LN: WMK - - - - - CAUTION This product must be installed exclusively by professionally qualified personnel in accordance with the requirements of the standards AS/NZS 5601, AS/NZS 3498, AS/NZS 3500.4,...
Page 2
Owner or User or is installed – The appliance must be used as intend- on another system. ed by Sime who is not responsible for – Installation and maintenance of this any damage caused to persons, ani- appliance must be carried out by a...
Page 3
RESTRICTIONS IT IS FORBIDDEN IT IS FORBIDDEN – To allow children under the age of 8 to – To expose the boiler to atmospheric use the appliance. The appliance can agents. These boilers can also be in- be used by children no younger than stalled in partially covered areas, as 8 years old, by people with physical per EN 15502, with a maximum ambi-...
Dear Customer, TABLE OF CONTENTS Thank you for purchasing a Sime Edea HM 40 boiler, a new-gen- eration modulating condensing device with technical features and excellent performance, allowing you to satisfy your heating OPERATING WITH EDEA HM 40 and instant domestic hot water requirements with the utmost Control panel .
This allows the user to scroll through the parameters or CAUTION decrease the values. – Access to the control panel of model Edea HM 40 e > is possible after loosening screws (1) and removing This allows the user to scroll through the parameters or panel (2).
The initial start-up of Edea HM 40 must be carried out by profes- sionally qualified personnel, after which the appliance can func- – open one or more hot water taps. Edea HM 40 will work at its tion automatically. It may be necessary for the user to restart maximum power until the tap or taps are closed.
Fault / malfunction codes When it is time to perform maintenance on the boiler, the If, during the operation of Edea HM 40 , an anomaly/fault occurs, symbol shows on the display. the display will show “ALL” followed by the anomaly code.
“WINTER mode” or twice from the “SUMMER mode” bottom part of the appliance, make sure that the to put the Edea HM 40 in stand-by. The display will show "- -" system components and pipes are not hot (risk of burning).
INSTALLATION AND SERVICE Installation record - installer details Company name _______________________________________________________________________________________ Company address _______________________________________________________________________________________ _______________________________________________________________________________________ Telephone _______________________________________________________________________________________ Mobile _______________________________________________________________________________________ Email _______________________________________________________________________________________ Certificate of compliance/certification number ______________________________________________________________________ Authorised persons license number _______________________________________________________________________________ Installers name _______________________________________________________________________________________ Installers signature _______________________________________________________________________________________ Installation date _______________________________________________________________________________________ Installation record - system details Model number _______________________________________________________________________________________...
HANDOVER INSTRUCTIONS N° Description When done Fill in all the details on this Boiler manual. Instruct the end user on how to correctly operate the system. Including how to turn the system on and off, adjust the time and temperature settings. Instruct how to turn the heating system off in summer and on for winter.
Page 11
Service – 2 – Year 3 Date Service technician PIC Licence No. Name Service Company Contact phone number Work Completed Notes Service – 3 – Year 5 Date Service technician PIC Licence No. Name Service Company Contact phone number Work Completed Notes Service –...
Page 12
Service – 5 – Year 9 Date Service technician PIC Licence No. Name Service Company Contact phone number Work Completed Notes Service – 7 – Year 11 Date Service technician PIC Licence No. Name Service Company Contact phone number Work Completed Notes Service –...
Need help?
Do you have a question about the EDEA HM 40 and is the answer not in the manual?
Questions and answers