Packet Bridge - Shure MXA310 User Manual

Port TCP/UDP Protocol
23 TCP Telnet
53 UDP DNS
67 UDP DHCP
68 UDP DHCP
80* TCP HTTP
443 TCP HTTPS
2202 TCP ASCII
5353 UDP mDNS
5568 UDP SDT (multicast)
57383 UDP SDT (unicast)
8023 TCP Telnet
8180 TCP HTML
8427 UDP SLP (multicast)
64000 TCP Telnet
*These ports must be open on the PC or control system to access the device through a firewall.
†
These protocols require multicast. Ensure multicast has been correctly configured for your network.
See Audinate's website for information about ports and protocols used by Dante audio.

Packet Bridge

Packet bridge enables an external controller to obtain IP information from the control interface of a Shure device. To access the
packet bridge, an external controller must send a query packet over unicast UDP* to port 2203 on the Dante interface of the
Shure device.
1. Send a UDP packet with a minimum 1-byte payload .
Note: The maximum accepted payload 140 bytes. Any content is allowed.
2. The Shure device will send a response packet over unicast UDP to the controller, using a destination UDP port identical
to the source port of the query packet. The payload of the response packet follows this format:
Bytes
0-3
4-7
8-13
Description
Not supported
Domain Name System
Dynamic Host Configuration Protocol
Dynamic Host Configuration Protocol
Required to launch embedded web server
Not supported
Required for 3rd party control strings
†
Required for device discovery
†
Required for inter-device communication
Required for inter-device communication
Debug console interface
Required for web application (legacy firmware only)
†
Required for inter-device communication
Required for Shure firmware update
Content
IP address, as 32-bit unsigned integer in network order
Subnet mask, as 32­bit unsigned integer in network or­
der
MAC address, as array of 6 bytes
Shure Incorporated
Factory De­
fault
Closed
Closed
Open
Open
Open
Closed
Open
Open
Open
Open
Closed
Open
Open
Open
32/42