Table of Contents
Advertisement
Available languages
Available languages
EN
Clean the dust filter
CAUTION
Use only original manufacturer's replacement parts, accessories and attachment. Failure to do so can
cause possible injury and poor performance.
• Press the locking block, then remove the dust tank from the unit, and separate the dust tank and
cap with filter.
• Holding the dust tank cap, twist the filter counterclockwise to disassemble it from the cap.
• Clean the filter by gently tapping or brushing dirt off. If needed, wash the filter under running water
and let it air dry before reusing.
DANGER
Risk of electric shock!
Turn off the appliance and remove the main plug prior to performing any care and maintenance work. Repair work and work on the electrical
components may not only be performed by an authorized customer service. You can rectify minor faults yourself with the help of the following
overview. If in doubt, please consult the authorized customer service.
Machine refuses to start
Fluctuating pressure
Machine stops
Machine pulsating
Machine starts, but no water
comes out
ENVIRONMENTAL DISPOSAL
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
9
Symptom
• Machine not plugged in.
• Defective socket.
• Fuse has blown.
• Defective extension cord.
• Pump sucking air.
• Valves dirty, worn out or stuck.
• Pump seals worn out.
• Incorrect mains voltage.
• Thermal sensor activated.
• Nozzle partially blocked.
• Air in inlet hose.
• Inadequate supply of mains
water.
• Nozzle partially blocked.
• Water filter blocked.
• Hose kinked.
• Pump/hoses or accessory
frozen.
• No water supplies.
• Water filter blocked/Nozzle
blocked.
WWW.NIKOLAOUTOOLS.COM
Cause
Recommended action
• Plug in machine.
• Try another socket.
• Replace fuse. Switch off other
machines.
• Try without the extension cord.
• Check that hoses and connections
are airtight.
• Clean and replace or refer to local
distributor.
• Clean and replace or refer to local
distributor.
• Check that the mains voltage
corresponds to specification on the
model tag.
• Leave the washer for 5 minutes to
cool down. Clean the nozzle.
• Allow machine to run with open
trigger
pressure resumes.
• Check that the water supply
corresponds
required.
NOTE! Avoid using long, thin hoses
(min. 1/2"). Clean the nozzle/Clean
the filter.
• Straighten out hose.
• Wait for pump/hoses or accessory
to thaw. Connect inlet water.
• Clean the filter/Clean the nozzle.
until
regular
working
to
specifications
Dust tank cap
Advertisement
Table of Contents
