BorMann PRO BPW3130 Instruction Manual page 6

EN
Pressure washer operation
CAUTION
- Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to avoid damage.
- Make sure the power switch is set to "OFF" position and insert the plug into a properly installed socket.
ATTENTION
- The washer must be used on a secure and stable surface in a standing, upright position.
Connect the product to power and water supply as described:
• Open the water supply.
• Hold the trigger gun with both hands.
• Direct the nozzle of the chosen accessory away from you towards the surface to be cleaned.
• Unlock the trigger and press it until a constant amount of water flows through the nozzle, to allow air trapped in the
hose to escape.
• Release the trigger.
• Turn on the switch "HPW".
• Hold the trigger gun with both hands. Direct the water jet to the object to be cleaned and press the trigger.
WARNING
- Beware of the kickback when pressing the trigger!
Using the adjustable spray nozzle- Fan Nozzle
The pressure washer is equipped with an adjustable nozzle, the nozzle tip can be adjusted from pencil spray to fan spray by turning the nozzle tip adjustable knob.
Vacuum Cleaner operation
CAUTION
Make sure the power switch is set to "OFF" position and insert the plug into a properly installed socket.
1. To use the appliance as the vacuum, insert the vacuum tube into the air inlet, and twist clockwise to secure.
2. Select the desired accessory, connect it with the other end of the hose, and press firmly to secure, then turn on the switch "VC", then can use it to clean.
3. Make sure the filter and dust tank are installed before starting, and make sure the vacuum hose is installed properly and locked securely in the air inlet.
4. During vacuuming, always use the suction hose, hold the suction hose at a distance of approximately 1cm, above the material to be vacuumed.
Blower Mode
1. Make sure the vacuum hose is installed properly and locked securely in the air outlet, and install the desired cleaning accessory onto the end of the hose.
2. Turn on the switch "VC", then can use it to clean.
Note: During the whole blowing process, keep the air inlet clear to maintain stable air flow.
When the vacuuming job is done, return the switch to the OFF position and unplug the power cord. Disassemble and store all the accessories.
6
Pencil spray Fan spray
WWW.NIKOLAOUTOOLS.COM
Adjustment knob
Nozzle
Vacuum hose
Dust brush All purpose nozzle