BorMann PRO BPW3130 Instruction Manual page 7

EN
Interrupting operation
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Put the trigger gun with the spray wand into the parking position.
• During longer breaks (more than 5 minutes), also turn the appliance off using the power switch.
Stop operation
Pressure washer
• Release the lever of the trigger gun.
• Turn off the appliance switch
• Disconnect the mains plug from the socket.
Only separate the high-pressure hose from the trigger gun or the device when there is no pressure in the system.
• Press the lever of the trigger gun to release any remaining pressure in the system.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
ATTENTION
• When disconnecting the supply or high-pressure hose, warm water may leak from the connection after operation.
• Detach the appliance from the water supply.
Dust tank
The dust tank needs to be emptied every time after using to avoid deterioration and obstructing air flow, which will reduce the performance of the vacuum.
Follow the instructions below to clean the dust tank.
• Switch OFF and unplug the appliance.
• Press the dust tank lock and pull out the dust tank at the same time.
• Grab the dust tank cap and turn it counterclockwise, the dust tank cap with filter be removed from the dust tank.
• Remove any debris or dust from the dust tank. Rinse the dust tank with warm water if needed.
TRANSPORTATION
CAUTION
Risk of personal injury or damage! Mind the weight of the appliance during transport.
When transporting by hand
• Switch the product off and disconnect it from the water and power supply.
• Lift the appliance by its transport handle.
7
WWW.NIKOLAOUTOOLS.COM
Dust tank cap with filter