Industry Canada (Ic/Ised) Statement - HETRONIC ERGO F21 User Programming Manual

To comply with FCC RF exposure compliance requirements, this device and its antenna must not be co-located with, or operating
in conjunction with, any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a residential environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

12.3 Industry Canada (IC/ISED) Statement

IC RF Exposure Statement
This device meets the IC requirements for RF exposure in public or uncontrolled environments.
IC Warning
This product complies with Industry Canada's licence-exempt RSS standards. Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
USER MANUAL |
24
ERGO F21