Device Overview; Turning On The Device; Bike Light Status Leds; Device Settings - Garmin VARIA RCT715 Owner's Manual

The lever must be flush with the base.
9 Adjust the headlight angle, and use the 4 mm hex key to tighten the screw.
NOTE: You should check the tightness of the screw periodically.

Device Overview

Hold for 1 sec. to turn the device on.
Hold for 2 sec. to turn the device off.
Device key
Hold to enter pairing mode
Select to change operating modes.
Status LED View device status

Turning On the Device

1 Hold the device key for 1 second.
The first time you turn on the device, it enters pairing mode. The status LED flashes purple. The device can
be paired with a wireless remote or Edge device.
2 Hold the device key for 2 seconds to turn off the device.
The next time you turn on the device, it is in high intensity mode.

Bike Light Status LEDs

LED Activity
Solid red
Flashing red
Flashing green
Solid green
Flashing blue
Flashing purple
Alternating blue and green The device is uploading software.
You can remotely control your Varia devices and customize settings using your compatible Edge device. This
section contains instructions for the Edge 830 and 1030 devices. Other compatible Edge devices use similar
settings.
6
(Pairing Your Bike Light with Your Edge 830 or 1030, page
(Bike Light Status LEDs, page
Status
An error occurred while charging, or the device shut down to prevent overheating.
The battery is low.
The battery is charging.
Charging is complete.
The device is in smart mode and can be controlled by a paired wireless remote or
Edge device.
The device is in pairing mode.

Device Settings

6).
7).
Device Settings