Screen Lock Function; How To Control A Video Door Phone Hardware Reset - urmet domus 1741 Instructions Manual

How to send a panic alarm:
• Turn on the screen, if off, by tapping it at any point or by pressing the Home button on the Video door
phone.
• Tap the icon
or a switchboard is present in the system (see section "Configurations").
• In the pop-up page that opens tap the CONFIRM button to control the alarm.
ATTENTION! In any case, even in the absence of confirmation, the alarm message will
be sent at the end of the timeout (5 seconds), unless you cancel the sending by pressing
the CANCEL button.
On receiving the Panic Alarm message, the switchboard operator can listen to what is going on inside
the apartment, next to the Video door phone. Ambient listening can only be stopped by the switchboard
operator and can continue without any time limits. Ambient listening enabling in the apartment must be
done by the installer (for more information, refer to the Ipercom manual on www.urmet.com).
The panic alarm can also be activated via an external device, such as a button, connected to
the terminal block behind the Video door phone. In this case the Panic Alarm message will be
sent directly without any request for sending confirmation.
1.7

SCREEN LOCK FUNCTION

To lock the video door phone screen, press and hold the Home key on the Video Door Phone until the
following screen is displayed.
The screen is inhibited for 20 seconds, after which it resumes operation.
It is possible to unlock the lock screen function early by pressing the Home key again or by following the
instructions shown on the screen.
The screen lock function is useful when you want to clean the screen, to avoid unintentional activation of
the Video Door Phone functions.
1.8

HOW TO CONTROL A VIDEO DOOR PHONE HARDWARE RESET

For a hardware reset of the Video door phone, press and hold the centre button of the Video door phone
until it restarts.
DS1741-004A
always visible in the bottom left corner of the screen, unless it had been disabled
9