Screen Lock Function; How To Control A Video Door Phone Hardware Reset - urmet domus IPerCom VOG 7 1761 User Booklet

How to send a panic alarm:
• Turn on the screen, if off, by tapping it at any point or by pressing the Home button on the IP Video
door phone.
• Touch the icon in the lower left corner of the screen, unless it is disabled in the configuration
parameters or there is no exchange in the system (for more information, refer to chapter Configurations
Parameter configuration
in the
• In the pop-up page that opens, press the CONFIRM button to send the alarm.
ATTENTION! In any case, even in the absence of confirmation, the alarm message will
be sent at the end of the timeout (5 seconds), unless you cancel the sending by pressing
the CANCEL button.
On receiving the Panic Alarm message, the switchboard operator can listen to what is going on inside
the apartment, next to the Video door phone. Ambient listening can only be stopped by the switchboard
operator and can continue without any time limits. Ambient listening enabling in the apartment must be
done by the installer (for more information, refer to the Ipercom manual on www.urmet.com).
The panic alarm can also be activated via an external device, such as a button, connected to
the terminal block behind the Video door phone. In this case the Panic Alarm message will be
sent directly without any request for sending confirmation.
1.7

SCREEN LOCK FUNCTION

To lock the video door phone screen, press and hold the Home key on the IP Video Door Phone until the
following screen is displayed.
The screen is inhibited for 20 seconds, after which it resumes operation.
It is possible to unlock the lock screen function early by pressing the Home key again or by following the
instructions shown on the screen.
The screen lock function is useful when you want to clean the screen, to avoid unintentional activation of
the Video Door Phone functions.
1.8

HOW TO CONTROL A VIDEO DOOR PHONE HARDWARE RESET

For a hardware reset of the Video door phone, press and hold the centre button of the Video door phone
until it restarts.
DS1761-024
booklet).
9