ICON Health & Fitness NordicTrack EXP10i User Manual page 13

12. Firmly tighten the two 3/8" x 2 1/4" Screws (2)
and the two 3/8" x 1 1/4" Screws (1) in the Right
Upright (85).
Repeat this step on the left side of the
treadmill.
13. Identify the Right Inner Base Cover (91). Slide
the Right Inner Base Cover onto the Upright
Base (94), under the Belly Pan Wire (107), as
shown in the inset drawing. Make sure that the
Belly Pan Wire is in the notch (M) in the Right
Inner Base Cover as shown.
Then, slide the Right Base Cover (89) downward
onto the Right Inner Base Cover (91).
Repeat this step on the left side of the tread-
mill with the Left Inner Base Cover (not
shown) and the Left Base Cover (not shown).
Note: There are no wires on the left side of the
treadmill.
14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see page 28). Note: Extra hardware may be
included.
12
85
1
13
89
85
M
94
91
13
2
1
107
M
107
91