Din Rail Mounting - Advantech ICR-4133 Hardware Manual

1. Product Overview

1.9 DIN Rail Mounting

You can attach the DIN rail clip to the router for mounting it onto a DIN rail that complies with the 60715
standards. The default position of the clip is depicted in Figure 9. If necessary, the clip can also be rotated
vertically.
When attaching the clip, tighten the screws with a maximum torque of 0.4 Nm.
To remove the router from the DIN rail, lightly push down on the router to disengage the bottom part of the
DIN rail clip from the rail. Then, pivot the bottom part of the router away from the DIN rail, as demonstrated
in Figure 10.
ICR-4133 Hardware Manual
Figure 9: Default Position of the DIN Rail Clip
Figure 10: Removing Router from the DIN Rail
1.9 DIN Rail Mounting
12