Table of Contents
Advertisement
3. Commissioning Mode Page 3
C
• The set maximum feed time will be
displayed. This setting is the time limit
for the water to fill the cylinder to the fill
pin before engaging a caution alarm. The
default setting is 600 seconds. This may
need adjusting to suit site specific water flow
rate conditions.
• The set maximum drain time will be
displayed. This setting is the time duration of
the drain. The default setting is 3 seconds.
This can be increased or decreased to suit
the specific site conditions.
• The control board software version will be
displayed.
• The touchscreen software version will be
displayed.
4. Commissioning Mode Page 4
By connecting via WIFI, you can remotely
monitor and change settings via a Modbus
application. An IP address will be automatically
assigned in this instance.
Page No 30 of 80
Vapac, Virtuoso VE Humidifier, Installation Manual, EN 2024-01, D301474 Iss 0
5. Commissioning Mode Page 5
If the unit is connected to a Modbus input, the
various Modbus settings can be adjusted via this
page.
Service Mode
If service mode is selected from the mode
selection screen by entering the PIN 4112, the
touch screen will display various parameters that
can be viewed and changed as shown below.
• Pressing the home button at any time in
service mode will revert to the applicable
normal operation screen.
• Pressing the setup button at any time in
service mode with go to the mode selection
screen described on page 8 previously.
• Pressing the forward button at any time in
service mode will go forward one screen.
• Pressing the back button at any time in
service mode will go back one screen.
1. Service mode page 1
• Pressing and holding the fill button will fill
the cylinder until the button is released or
the cylinder is full.
• Pressing and holding the drain button will
drain the cylinder until the button is released
or the cylinder is fully drained.
Advertisement
Table of Contents
