Touch Screen Display Panel; Initial Startup Mode; Starting Up Please Wait; Normal Operating Mode - Vapac VIRTUOSO VE05-1P Installation And Operating Manual

Touch screen display panel

The touch screen display panel allows access to
the following "on-screen" modes:-

• Initial Startup Mode

• Normal Operating Mode

• Commissioning Mode via PIN (6787)
• Service Mode via PIN (for service engineer
use only)
• Advanced Mode via PIN (for service engineer
C
use only)
Initial Startup Mode

1. Starting Up Please Wait

When power is initially applied to the unit,
the "Starting Up Please Wait..." screen will be
displayed for up to 3 minutes whilst the system
carries out its start up checks.
Once the system has completed its start up
checks, the unit will enter Normal Operating
Mode. If the unit has not previously been
commissioned, the procedures described in
"Commissioning Mode"on page 28 must
be carried out for the unit to enter normal
operating mode.
Normal Operating Mode
Once the initial setup has been completed,
the unit will switch to normal operating mode
and the touch screen will show the operational
status of the unit: STANDBY, STEAMING,
FILLING, DRAINING, SERVICE DUE, CAUTION
ALARM and CRITICAL ALARM (as shown in
the following screenshots and described in the
"Operation" section on page 37
Note that the Home button will not work in this
mode.
Page No 26 of 80 Vapac, Virtuoso VE Humidifier, Installation Manual, EN 2024-01, D301474 Iss 0
1. Standby mode
• In standby mode, the unit is operating
and awaiting a call for humidification. The
display will show "interlock open" until the
unit enters steaming mode (i.e. there is no
demand for steam from an external enable
signal).
2. Steaming mode
• In steaming mode, the unit is operating
normally and creating steam.

3. Filling mode

• In filling mode, the unit is operating normally
and the cylinder is being filled
following).