Mode Selection; Commissioning Mode - Vapac VIRTUOSO VE05-1P Installation And Operating Manual

7. Mode selection

If the setup button is touched during normal
operation (or any mode other than initial setup),
the mode selection screen will appear
C
• Touching the Commissioning Mode
button will go to a PIN entry screen. Enter
6787 then touch the tick to go to the

commissioning mode

• Touching the Service Mode button will go to
a PIN entry screen. Enter 4112 then touch
the tick to go to the service mode screen.
• Touching the Advance Mode button will go
to a PIN entry screen. Enter 9999then touch
the tick to go to the advanced mode screen.
• Touching the Change Language button will
go to the Select Language page described
below.
• Touching the Home button will revert to the
applicable normal operating
8. Select language
• Touch the flag for the required language
• Touch the tick to save the required selection
Commissioning Mode
If commissioning mode is selected from the
mode selection screen by entering the PIN 6787,
the touch screen will display various parameters
that can be viewed and changed as shown
below.
Page No 28 of 80 Vapac, Virtuoso VE Humidifier, Installation Manual, EN 2024-01, D301474 Iss 0
screen.
screen.
1. Commissioning Mode Page 1
• The input type notifies the control software
what control input it needs to look for.
When the adjacent Change button is
pressed, the Select Input Type screen opens
as below to select the required input.
• The Select Input Type Screen allows the type
of control for the humidifier to be set. One
of the options MUST be selected for the
unit to operate. Ensure that the associated
control input method is provided. There are
5 different options available:-
a) External demand signal 0-10V should be
selected if you wish to control the unit via
a 0-10V external demand signal from, for
example, a BMS.
b) Humidity Sensor 0-5V should be selected
if you wish to control the unit via a 0-5V
humidistat.
c) Humidity Sensor 0-10V should be selected
if you wish to control the unit via a 0-10V
humidistat. This is the default setting.
d) On/Off Input should be selected if you
wish to control the unit via a simple 0-10V
on/off control.
e) Modbus should be selected if you wish to
control the unit via a Modbus interface.