Minor Maintenance Tips
f. Later adjust the nut on Lh side by matching
the index mark with respect to Rh side
index. Ensure that both the sides are in
same index marks.
g. Tighten the adj uster locknut by 13mm
spanner against chain slack adjusting nut.
h. Finally torque the spindle and axle nuts to
7 kgm.
Warning
Chain slackness beyond 30mm will lead to chain
slippage.
Maintain drive chain slackness within the specified
limits at every 1000 kms interval.
Please Check the front and rear wheels are correctly
aligned, after the chain adjustment.
CHAIN LOCK FITMENT
The open end of the chain master link lock should
face opposite to normal direction of chain rotation.
Warning
The f itment of lock in wrong direction other than
shown above can lead to its falling off, and thus can
cause the sudden disconnection of the chain during
the drive.
67