Primary Chain Tension Adjustment; Chemical Method; Clutch; Oil Level Check - Royal Enfield ELECTRA Service Manual

*
Insert it into the pipe and operate the drill. .
PRIMARY CHAIN TENSION
6 MM WIRE ROPE
*
The Loose splines of the wire rope will cut
and
remove
the carbon
CHEMICAL METHOD
*
Close the tube at one end.
COSTIC SODA SOLUTION
*
Prepare a solution by mixing 1 kg Caustic
Soda with 8 Ltrs. of water.
NOTE:
Prepare the solution in plastic container. Do not
allow caustic soda or the solution to come in
contact with skin or cloth
*
Fill the pipe with the solution
*
Keep for 45 to 60 minutes
*
Remove the solution
*
Clean the pipe thoroughly in running water.
ADJUSTMENT (EVERY 3000 KMS)
*
Check the slackness at the centre of the
top run.
*
If more, adjust as follows
·············-············ ································----· ······················-············--············-·········-··
*
Loosen adjuster lock nut
*
Screw out the adjuster till a play of 5 to
6mm is achieved at the centre
*
Tighten the lock nut.
CLUTCH
OIL LEVEL CHECK (EVERY 1000 KMS)
*
Loosen
I
remove the level plug.
*
The clutch oil should slowly ooze out
*
If not, top up with 1 SW-40 API SG oil.
OIL CHANGE
(refer Periodical Maintenance Chart for
frequency)
*
Place motorcycle on its centre stand on a
firm flat surface.